Jump to content
Ultimaker Community of 3D Printing Experts

Recommended Posts

Posted · printing with 0.25

after a long time i tried out the 0.25 nozzle, but it went all wrong.

the matrial came from above from the Olsen block and not from the nozzle. Now I can only change the nozzles if I heat it up a little.

In cura I change the setting for the nozzle to 0.25 and wallthickness to 0.5

I was trying with different materials (pla,abs,xt) from colorfabb nothing work.

1. Is there a way to get out the matrial from the Olsen block and the nozzle?

2. what for settings do I need for a successful printing ?

  • Link to post
    Share on other sites
    Posted · printing with 0.25

    I didn't change any settings at all other than layer height when I first used the .25 nozzle. I think when you set nozzle size in cura it automagically sets first layer height n such to adjust for it.

    It sounds to me like maybe you didn't tighten the nozzle when you put it on. (I made that mistake once.) Also, maybe increase temperature +5 degrees? it could be it was a tad too low before, but sufficient to still push out the larger diameter nozzle opening, but the smaller one wasn't.

  • Link to post
    Share on other sites
    Posted · printing with 0.25

    If you are in expert/full settings view in Cura and you only change the nozzle diameter manually, your print will fail. But if you use the quickprint settings for 0.25mm for the UM2+ (lower speeds) everything should be fine.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Ultimaker Transformation Summit

        On April 20 - April 23 we will host the Ultimaker Transformation Summit. Come talk to us via Live chat and get inspired by any of our relevant presentations!
        • 5 replies
      • New here? Register your Ultimaker for free 3D printer onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 0 replies
    ×
    ×
    • Create New...