Jump to content
UltiMaker Community of 3D Printing Experts

UltiMaker 2+ Extender System Plate Problem


Recommended Posts

Posted · UltiMaker 2+ Extender System Plate Problem


The temperature reading of system plate got wrong readings. it said 66C when room temperature is just 18C. I haven't heat up the system plate yet. Is this a temperature sensor problem or cable problem ?

Thanks in advance.

Best Regards,

Kevin LO

  • Link to post
    Share on other sites

    Posted · UltiMaker 2+ Extender System Plate Problem

    Hi Kevin,

    it could be both. Check for loose cables at the back of the heated bed. Also take off the cover at the bottom of the printer (it is held in place by two screws) and inspect the board for any loose or broken connections.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now

    • Our picks

      • New here? Get ahead with a free onboarding course
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 14 replies
    • Create New...