Jump to content
kevinlo22

UltiMaker 2+ Extender System Plate Problem

Recommended Posts

Posted · UltiMaker 2+ Extender System Plate Problem

Hi ALL,

The temperature reading of system plate got wrong readings. it said 66C when room temperature is just 18C. I haven't heat up the system plate yet. Is this a temperature sensor problem or cable problem ?

Thanks in advance.

Best Regards,

Kevin LO

Share this post


Link to post
Share on other sites
Posted · UltiMaker 2+ Extender System Plate Problem

Hi Kevin,

it could be both. Check for loose cables at the back of the heated bed. Also take off the cover at the bottom of the printer (it is held in place by two screws) and inspect the board for any loose or broken connections.

Share this post


Link to post
Share on other sites
Posted · UltiMaker 2+ Extender System Plate Problem

Yes. It was a bad-contact problem on the motherboard side.

Thanks.

Best Regards,

Kevin

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!