Jump to content
Ultimaker Community of 3D Printing Experts

A plea for help near Castle Rock, CO...


Recommended Posts

Posted · A plea for help near Castle Rock, CO...

I have yet to produce one single successful print of anything significant. I have been tweaking and playing and adjusting and reading and it's getting really frustrating... Once I seem to overcome one issue, another manifests.

Even trying to print some little doodads from thingiverse and I can't make it happen. I get blobs and strings. Half the time the filament stops feeding. I have loosened and tightened. I have sacrificed small animals to gods I've never even heard of. I just can't figure it out.

If there are any folks near Castle Rock, CO that might be willing to help me figure out what I am not doing properly I would really appreciate it...

Thanks.

J

  • Link to post
    Share on other sites
    Posted · A plea for help near Castle Rock, CO...

    Hey J, first of all tell, us what you workflow is, setting up the printer, what kind of filament you are using and settings in Cura.

    Next post some images of the results and problems you are getting,

    these will greatly help in understanding what is going on :)

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...