Jump to content
Ultimaker Community of 3D Printing Experts
rlrcstr

A plea for help near Castle Rock, CO...

Recommended Posts

I have yet to produce one single successful print of anything significant. I have been tweaking and playing and adjusting and reading and it's getting really frustrating... Once I seem to overcome one issue, another manifests.

Even trying to print some little doodads from thingiverse and I can't make it happen. I get blobs and strings. Half the time the filament stops feeding. I have loosened and tightened. I have sacrificed small animals to gods I've never even heard of. I just can't figure it out.

If there are any folks near Castle Rock, CO that might be willing to help me figure out what I am not doing properly I would really appreciate it...

Thanks.

J

Share this post


Link to post
Share on other sites

Hey J, first of all tell, us what you workflow is, setting up the printer, what kind of filament you are using and settings in Cura.

Next post some images of the results and problems you are getting,

these will greatly help in understanding what is going on :)

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 130 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!