Jump to content
Ultimaker Community of 3D Printing Experts

Atomic method on UM2+ error


vince805
 Share

Recommended Posts

Posted · Atomic method on UM2+ error

Following these directions: https://ultimaker.com/en/resources/18781-atomic-method

When trying to heat the printer up to 260 it gives an error saying something about the temp sensor and i have to shut it off and back on again. I ended up doing it at 230 and it worked kind of but just wondering if this is just my machine doing this or if the temp is too high.

  • Link to post
    Share on other sites

    Posted · Atomic method on UM2+ error

    Is the temp overshooting when you set it to 260? At what temp does it alarm?

    Just check if any of the connections are loose and the temp sensor is fully inserted and not loose.

    I only heat mine up to 230 or so when I do atomic pulls and it works just fine.

  • Link to post
    Share on other sites

    Posted (edited) · Atomic method on UM2+ error

    Have you updated your firmware? On the first batch(es) of printers that went out the firmware used an incorrect PID profile for the new temperature sensor which might be what is causing the problem for you.

    edit: Oh, and do a factory reset after the firmware update just to make sure the new settings take effect.

    Edited by Guest
  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...