-
Our picks
-
UltiMaker Cura 5.4 stable released
ArunC posted a topic in UltiMaker Cura,
The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!-
-
- 58 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
Labern 774
Yes you can use that.
The one supplied by UM is Magnalube-G which has a PTFE gelling agent which does make it a better grease long term then lithium grease which has a soap based gelling agent. You may find that you have to clean it and re-apply a bit more often as the oil can sepperate away from the soap.
Link to post
Share on other sites