Jump to content
Ultimaker Community of 3D Printing Experts

does speed adjust during printing effect material flow?

Recommended Posts

Yes it will. You can get dimensional differences due to the flow vs temperature. You may also experience under or over extruding depending on which way you alter the speed.

You may need to adjust the temp as well as the speed and if you adjust the temp down do it slowly so it doesn't undershoot and cause under-extrusion.

Share this post

Link to post
Share on other sites

i find cura doesn't seem to do a very good job at judging the flow rate required when printing at high speeds. unless its more dependent on what material you're using. ive been printing a lot of abs and while printing at 100 mm/s (with increased temp to compensate for the speed) i still have to up the flow rate to 120% to get proper bed/layer adhesion

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Introducing Ultimaker Cura 3.6 | Beta
      Ultimaker Cura 3.6 | Beta is available. It comes with new features, bug fixes, and UX improvements. We would really like to have your feedback on it to make our stable release as good as it can be. As always, you can download the beta for free from our website, for Windows, MacOS, and Linux.
        • Like
      • 95 replies
    • Print Core CC | Red for Ruby
      Q: For some users, abrasive materials may be a new subject matter. Can you explain what it is that makes a material abrasive when you are not sure which print core to use?
      A: Materials which are hard in a solid piece (like metals, ceramics and carbon fibers) will generally also wear down the nozzle. In general one should assume...
        • Thanks
      • 30 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!