Jump to content
Ultimaker Community of 3D Printing Experts
Franny500

Maximum rectangle that can be printed on UM2 +

Recommended Posts

This has probably been done to death, but what is the maximum rectangle/square you can print on an Ultimaker 2+?

Website states 223 x 223 but I've been reliably informed it isn't that by a someone looking to print the biggest possible rectangle/square with all first layer touching build-plate?

Edited by Guest

Share this post


Link to post
Share on other sites

Hi Franny500,

I attached a Cura image for you which shows a bit what you were looking for.

The fact is that there are glass clips on the bed which take a way a few mm in the corners of the print bed. So the largest square will be a little bit smaller than for example the print I choose. I would advice to go no larger than 221x221 mm to reduce the risk of your printhead slamming against the sides. Other than that you are good to go!

5a331b12ccd67_Schermafbeelding2016-04-15om15_50_43.thumb.png.e27c669c747af899889526304e358c8f.png

5a331b12ccd67_Schermafbeelding2016-04-15om15_50_43.thumb.png.e27c669c747af899889526304e358c8f.png

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 122 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!