This beautiful 3D printer belongs on a spaceship

[frederiekpascal 193]

check out this article : http://www.theverge.com/2016/4/18/11450276/zmorph-sx-2-3d-printer-is-beautiful

it's about this product fyi https://www.zmorph3d.com/products/zmorph-2-0-sx

looks pretty cool

Edited April 18, 2016 by Guest

[danilius 118]

It looks pretty and amazing as well as pretty amazing, but as you can see in the "use cases" section, it's an all-round compromise. It does everything OK. Which is fine, really. If you are after precision or quality surface finish then you will have a hard time with that machine, though. I need both; precision and surface finish.

So far I have not found a 3D printer that has made me think, "Oh I wish I had bought that one instead of the Ultimaker". The day I do think that that, I will buy it.

[peetersm 124]

The dual extruder is a mixing single nozzle. Like the e3d Cyclops, BUT they say their software can do "experimental limited material mixing".

That sounds fun to play with. But not at that price.