Jump to content

bad pwc fan controller

tcconsulting
 Share

Recommended Posts

tcconsulting

tcconsulting 0

Posted
Posted · bad pwc fan controller

i have a bad fan pwc controller next to led plug in i cant controll the speed of cooling fans on ultimaker2 board .I would like to know if i could possible to controll the j20 fan connector or heater 2 connector as that, if so how do i go into the firmware and make it work thanks for the help ,i use 2- 12 volt fans connnected all red wires together and then black wire together

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.4 stable released

        UltiMaker Cura 5.4 stable released

        ArunC posted a topic in UltiMaker Cura,

        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...