Ulticontroller settings

[thevictor11 0]

Hi guys, just installed the Ulticontroller and being someone who`s never used a 3D printer until today I have a few questions!

What is the % that the knob changes?

Is there a way I can cancel a print once it's started if it isn't connected to the computer?

And finally, is anyone bothered that the controller is covering up the front logo? I really like the way it looks.

Anyways, thanks in advance guys. Learning all of this is pretty overwhelming especially nearing the end of the semester lol.

[Daid 304]

On the status screen it is the speed that you change.

I have my controller on the side of the machine, this way it does not cover up the logo =)

You can cancel an SD card print by selecting the "stop print" menu item that shows instead of the "file menu" option once you started a print.

[thevictor11 0]

Thanks Daid, I guess I'll have to learn the whole speed/heating ratio to use that properly haha thanks for the help. I just realized I missed that there was an actual questions and help section. My fault for posting at 3am.