Jump to content
Ultimaker Community of 3D Printing Experts

Help to setup slicing engine with more cooling than default?


MarkHoe
 Share

Recommended Posts

Posted · Help to setup slicing engine with more cooling than default?

Hey everybody,

I have been upgrading my UMO+ with dual cooling. (almost like the UMO2).

Now i can see that by tuning the cooling om my printer while printing helps the printquality.

Therefore i would like a little bit of help with my settings so i can by default increase the cooling by about 30-40units.

I would like to make it a default setting so that i dont have to make a lot of changes to the gcode everytime i slice.

I use Repetier Host and slice with Cura engine. (if that helps)

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • The Ultimaker Showcase — October 14. What's new?
        Your dear friends at Ultimaker have some exciting news and insights for you!
         
        • 0 replies
      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 8 replies
    ×
    ×
    • Create New...