Jump to content
Ultimaker Community of 3D Printing Experts

Missing Filament


Katieb

Recommended Posts

Posted · Missing Filament

Hi, Katie,

Is that the side of the print that was against your glass?

Did you use glue on it?

If it's the side that was against your glass and you didn't use glue, the glass made need cleaning.

If you used glue, you may want to make sure to dilute it with water enough that the layer on the glass is totally flat.

  • Link to post
    Share on other sites
    Posted · Missing Filament

    What erin said.  It looks like a bit of glue.  I use a paint brush, add water, and spread the glue around very thin.  Then heat up the bed and it should dry within 5 minutes almost invisible.

  • Link to post
    Share on other sites
    • 2 weeks later...
    Posted · Missing Filament

    Thanks for your replies guys & girls ;)

    I dont use glue and I dont have a glass bed, but yes, it is the side thats facing the bed.

    There are no obvious holes or gauges in my bed surface so im not sure what is going on.

  • Link to post
    Share on other sites
    Posted · Missing Filament

    A little bit of the first layer probably got detached and caused that defect. Sometimes it can detach slightly, curl up a little bit because it gets hit by the head and then it gets smooshed down again as the next few layers are laid down.

  • Link to post
    Share on other sites

    Archived

    This topic is now archived and is closed to further replies.

    ×
    ×
    • Create New...