Jump to content
Ultimaker Community of 3D Printing Experts
droopas

Flickering in LCD

Recommended Posts

Has anyone experienced the content on the LCD jumping 1 pixel to the right every once in a while?

I have noticed while I use it that it occationally happens, perhaps once every minute or two ut only when servicing the printer.

- Droopas

Share this post


Link to post
Share on other sites

I seen it on mines running tinkergnome FW.

Had lcd glitching on my kossel printer.

Turn out to be a stepper motor wire to close to the lcd cables.

Its probably the same problem here

Share this post


Link to post
Share on other sites

I seen it on mines running tinkergnome FW.

Had lcd glitching on my kossel printer.

Turn out to be a stepper motor wire to close to the lcd cables.

Its probably the same problem here

 

That must be why they started shipping new Ultimakers with ferrite cores. Hmm... Time to find some ferrite.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×

Important Information

Terms of Use Privacy Policy