Jump to content
Ultimaker Community of 3D Printing Experts

Feeder moving reverse


Recommended Posts

Posted · Feeder moving reverse

Upgrading my UM2 to UM2+ with the kits. After installing, the feeder is moving in reverse. Cable on the board looks correct. And one more issue, the Ferrite Core is missing. Here is a photo of the E1 connector showing the cable for the feeder. Can anyone assist. Thank you.

UMB.thumb.jpg.788c360322161ed534aa66bbc448ac32.jpg

UMB.thumb.jpg.788c360322161ed534aa66bbc448ac32.jpg

  • Link to post
    Share on other sites

    Posted · Feeder moving reverse

    The UM2 firmware runs the feeder in the opposite direction of the UM2+ firmware, so like neotko said, updating to the UM2+ firmware on your machine will resolve the issue.

    Regarding the ferrite core; the ferrite core was a later addition to the printers, so the earlier UM2s don't have any. You don't have to have them, but if you want them, you should be able to find them online. With the UM2/UM2+ machines we put one around the Feeder and Y motor cables down by the electronics board, and one underneath the right hand cable cover wrapped around the X motor cable.

    • Like 1
    Link to post
    Share on other sites

    Posted · Feeder moving reverse

    Thanks for the reply. I have upgrade the firmware to 15.04.06. Well the problem is my mistake, I did not choose to "Add new machine" and select Ultimaker 2+. So now the loading is normal again. But now a new issue is up. After doing bed levelling. Test print and the head is now not touching the bed. Its stay abt a few mm off the bed. What have I done wrong this time? Please advice, anyone. Thank you.

  • Link to post
    Share on other sites

    Posted · Feeder moving reverse

    Did you run the leveling procedure again? The height of the UM2+ head is a little shorter so you have to re-level.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 8 replies
    ×
    ×
    • Create New...