Ultimaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I think there is a bug in one-at-a-time mode where it retracts then resets everything and forgets that it retracts and then retracts again and then unretracts. Maybe see if the bug is in cura 2.1.2?
The simplest solution is probably to use skirt. If you don't use brim then it will instead use skirt be default. Make sure the skirt is a minimum length (maybe 200mm?) to get the extruder flowing again.
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.
They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access.
Ready? Register your product here in just 60 seconds.
Recommended Posts
gr5 1,858
I think there is a bug in one-at-a-time mode where it retracts then resets everything and forgets that it retracts and then retracts again and then unretracts. Maybe see if the bug is in cura 2.1.2?
The simplest solution is probably to use skirt. If you don't use brim then it will instead use skirt be default. Make sure the skirt is a minimum length (maybe 200mm?) to get the extruder flowing again.
Link to post
Share on other sites