Jump to content
Ultimaker Community of 3D Printing Experts

extruder upgrade hitting back of gear.


Recommended Posts

Posted · extruder upgrade hitting back of gear.

The button head on the tensioner block of "bertha's upgrade" is pushing my big extruder gear outwards. Should I throw a 3rd washer under it. This would offset the extruder gear and the drive gear on the stepper motor. The drive gear sits a bit cock-eyed on the shaft as well so there's a spot every revolution of the motor that binds up against the extruder gear. Do these issues wear themselves in after a bit of use, or should they be taken care of now during assembly ?

Thanks

  • Link to post
    Share on other sites
    Posted · extruder upgrade hitting back of gear.

    The new tensioner is 5mm wider than the extruder's body. Assuming it's sitting nice and symmetrical that means it hangs out 2.5 mm on the gear side, plus another 1.5mm for the button head of the screw meaning a minimum of 4mm. Each washer's only 1.5mm, so it takes 3 washers, simple enough. What I really need is a straight gear for the drive motor, then the extrude gear wouldn't be binding up and walking all over the place.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...