Jump to content
Ultimaker Community of 3D Printing Experts

Are my fans dead?

Recommended Posts

Noticed during last print that both side fans are not working. Left one even lost one of the blades, somehow. They're not spinning if I override fan speed in setting during start of the new print. Fan for nozzle cooling working properly.

Could they break because of overheating? I use closed chamber.

If they are dead, can I buy me new fans at any hardware store? If so, what are the specs that I should pay attention to?

Edited by Guest

Share this post

Link to post
Share on other sites

You can check by going to maintence -> advanced -> fan speed and set to 100, if it doesn't spin something's up.

I would check the connection of the fan wires at the head first, it's under the black wrap near the head, just check to see that everything is connected.

Secondly, I would check to back to see if there's any pinching of the wires between the print head pieces. If you did maintenance recently, you might have pinched a fan wire.

Lastly, is the 3rd fan running? when your nozzle is 60+ degrees? The fan in the back blowing forward.

Share this post

Link to post
Share on other sites

Found the issue. Fans were not dead, thankfully, the green wire on the bundle of connectors inside the black flexible tube on the top of printhead teared off it's pin. It seems that these two fans connected successively, so it broke both of them. I soldered it back, and fans started to spin again. Main challenge was to actually stuff everything back into this damn tube without tearing something else - those huge connectors just refused to fit in at first.

Edited by Guest

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 85 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!