Jump to content
Ultimaker Community of 3D Printing Experts
PrintBotter

Printing with LDPE

Recommended Posts

Hey guys,

I am trying to print with LDPE (low-density polyethylene) and the print is continuing to warp. I have tried multiple settings but my current settings are: Nozzle Temp: 220 C, Bed Plate Temp: 70 C, Fan: 0 %

I have tried everything in mind:

-Blue tape with rubbing alcohol

-Blue tape with glue

-Glue on plate surface

-Bonding to PLA and ABS

-Adjusting settings (Bed temp, Nozzle temp, fan, speed, etc.)

-Draft shield

-Brim

Please help me out with suggestions! I am running out of options.

Thank you

Share this post


Link to post
Share on other sites

Hi there,

I know nothing of LDPE, but I have played with other special plastics and read a lot.

People say ABS sticks to Kapton (polyamide?) tape, with or without glue.

I've used crazy glue (cyanoacrylate?) glue on Kapton to get polycarbonate to stick (it mostly worked, but some warping on my single experiment).

There are also products like BuildTak and PEI tape that seem to be popular.

Also, others swear by super hold hair spray.

I have also seen people put a thin sheet of pegboard on top of the glass plate, so that the plastic can stick into the small holes. This would make for a rough bottom, but as a last resort....

Also, is LDPE dissolvable? Maybe you can make an LDPE version of ABS juice. You would probably want to see what the dissolving agent does to you glass plate, though, first.

Anyway, I have not tried all these things myself, but maybe these ideas can point you in the right direction.

Question: why LDPE?

If you gain any success, please share your results/insights it with the community. I have not read of anyone else trying LDPE, so your insights would be valuable. :)

Good luck! :)

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 117 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!