Jump to content

Heating Failed - Ultimaker Original

nad931

By nad931
in UltiMaker 3D printers

 Share

Recommended Posts

nad931

nad931 0

Posted
Posted · Heating Failed - Ultimaker Original

Hi,

So I'm experiencing a problem with Ultimaker Original. Everytime I try to heat the nozzle an error message flashes on the screen saying "Heating Failed". I've changed the temperature sensor and the thermocouple but still the same problem. The heater heats up till about 37 and then it doesn't and flashes the error message. I've also checked all the connections on the board and they're all fine.

Any help is highly appreciated.

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.4 stable released

        UltiMaker Cura 5.4 stable released

        ArunC posted a topic in UltiMaker Cura,

        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
        • 58 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...