Any idea why the honeycomb infill on the left looks so horrible and the infill on the right looks fine?
Do I need to slow things down?
Slicer: Simplify 3D
Quality Level: "Fast"
Printing Speed: 41.67mm/sec (2500mm/min)
Infill Pattern: Full Honeycomb
Infill Percentage: 25%
Layer Thickness: 0.25mm
Update (for those that care).
Cleaned off the Z axis screw and reapplied a little of the green grease that came with the printer.
Did a few Atomic Pulls.
When I pulled the fan shroud off to check the PTFE coupler, I found this beauty.
The heater block is encased in a blob of ColorFab XT. A little surprise left over from this failed print several weeks back. I didn't realized it had gotten up inside the fan shroud.
Heated up the print head and pulled it off with need