Jump to content
Ultimaker Community of 3D Printing Experts
Sign in to follow this  
3design

dust protection

Recommended Posts

Dust on the filament might block the nozzle, dust on the rods might lockup the axes or causes missed steps. Keeping your rods oiled should work against the dust on the rods (where there is oil, there cannot be dust) if you are afraid of dust on the filament, there are some options of installing cleaner before the feeder. (look on thingiverse for ideas)

Share this post


Link to post
Share on other sites

dust on the printing bed causes the first layer not to stick, but to bend and mess up. When I clean it gently with a humid paper and wipe away the water rest it with dry one, the layer sticks perfectly.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Our picks

    • Taking Advantage of DfAM
      This is a statement that’s often made about AM/3DP. I'll focus on the way DfAM can take advantage of some of the unique capabilities that AM and 3DP have to offer. I personally think that the use of AM/3DP for light-weighting is one of it’s most exciting possibilities and one that could play a key part in the sustainability of design and manufacturing in the future.
        • Like
      • 3 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!