Jump to content

pressure slot

Recommended Posts

Posted · pressure slot

hi i have a question , why print the printer a gap / slot in a complete part what I have done wrong ?IMG_20160825_125433.thumb.jpg.349eae45ab226278d7e7be8c0e5d540b.jpg

Ultimaker Orginal +


Share this post

Link to post
Share on other sites
Posted · pressure slot

Hi @Inter, welcome to the forums! :)

Such behavior is often triggered by a loose short belt, or at least not as tight as it should be.

You can tighten it by loosening the 4 screws that hold the motor in place, push the motor down as far as possible and tighten the screws again.

What version of Cura are you using?

With different wall thickness settings it can also influence your print.

Looking forward hearing from you!

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!