Jump to content
Local

Ultimaker 2 go Damaged itself?

Recommended Posts

Posted · Ultimaker 2 go Damaged itself?

Hi all, having some trouble with my Ultimaker 2 Go, almost at the end of a print the printer give me the Z axis is warning and pushes the platform up into the nozzle.

Cleaned the machine down made sure nothing was nothing obstructing it and after manually moving it up and down a couple of times,, started the machine up again.

Everything looked fine until I start a print, using the same gcode I've used three times in the last couple of days, same settings and filament and I get this......

I've done all the usual checks,nozzle's clean, settings are fine, to double check I did a factory reset but they're still coming out the same, anyone come across this before?

I think there might be a problem with the Z axis but I don't know how to check...

IMG_9915.thumb.JPG.20a87d124f0a9a60a6944f523d248b81.JPG

IMG_9915.thumb.JPG.20a87d124f0a9a60a6944f523d248b81.JPG

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!