Jump to content
yellowshark

Cura 2.3.0 not slicing

Recommended Posts

Posted · Cura 2.3.0 not slicing

OK I finished my software configuration and loaded a model. The message at the bottom right changed from "Please load a model" to "Preparing to slice..." and that is where it stayed. After 10 minutes I closed Cura and restarted, losded my settings Profile and the model and the same thing happened again.

Any ideas? It is a small model, centred on the bed and in 15.04.4 takes about 4 seconds to slice with same settings.

Share this post


Link to post
Share on other sites
Posted · Cura 2.3.0 not slicing

It never happened to me with a single model but I had a few times that duplicating a model multiple times and scaling some of them results in cura getting stuck in an endless slicing loop where it won't get out any more....

And as a side note, placing multiple models and scaling them is very time consuming as after you scale a model even only in z it gets moved to the centre of the bed.... pretty annoying...

Share this post


Link to post
Share on other sites
Posted · Cura 2.3.0 not slicing

Thanks for that. Just before going to bed last night I made some progress, establishing that it was a Machine Settings problem. I added another printer and chose Ultimaker 2 and the model sliced.

I had chosen a German Reprap Neo from the Other printer list and added my settings and gcode. This morning I decided to start again. Under Adding a Printer I chose “Custom printer” which I must have missed last night – not sure how as it is staring you in the face, but I did.

Setup my printer again and it all works.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Our picks

    • Ultimaker Cura 4.0 | Stable available!
      Ultimaker Cura 4.0 is mainly focused on the improved user interface and cloud integration.
      As always, we want to collect your user feedback for this release. If there are any improvements you can think of, feel free to mention it here and help us to shape the next release.
      • 20 replies
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!