Jump to content
Ultimaker Community of 3D Printing Experts

Feeder Motor


minivipers
 Share

Recommended Posts

Hello all,

my existing motor problem only occur while I was changing material but printing process, it works fine...

https://www.facebook.com/selcukfindik/videos/10154204413679191/

I think my feeder motor is not suitable...While I was building my ultimaker 2, I had chosen Pololu SY42STH47-1206A (I did not pay attetion at all ). however, its 6 leads and 4v voltage rate.

there are 4 types of "SY42STH47" motors ( http://reprap.org/wiki/NEMA_17_Stepper_motor )

and I need to know suitable version for feeder motor?

SY42STH47-1504A or SY42STH47-1684A / B

there are difference between Holding Torque and motor lenght...

Which one I need to choose?

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...