Jump to content
minivipers

Feeder Motor

Recommended Posts

Posted · Feeder Motor

Hello all,

my existing motor problem only occur while I was changing material but printing process, it works fine...

https://www.facebook.com/selcukfindik/videos/10154204413679191/

I think my feeder motor is not suitable...While I was building my ultimaker 2, I had chosen Pololu SY42STH47-1206A (I did not pay attetion at all ). however, its 6 leads and 4v voltage rate.

there are 4 types of "SY42STH47" motors ( http://reprap.org/wiki/NEMA_17_Stepper_motor )

and I need to know suitable version for feeder motor?

SY42STH47-1504A or SY42STH47-1684A / B

there are difference between Holding Torque and motor lenght...

Which one I need to choose?

Share this post


Link to post
Share on other sites
Posted · Feeder Motor

47 is the motor length. 168 stands for 1.68A which is the one that UM uses. However, the first two letters stand for the manufacturer, so you can have anything there.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!