UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
What is the best technique to remove support structures?
Posted
· What is the best technique to remove support structures?
If there's a lot I run over it with a blade to get rid of the larger chunks. After that I just sand what ever is left with 200 grit sandpaper. That usually takes care of what gets left on mine. Good luck!
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
Recommended Posts
thevictor11 0
If there's a lot I run over it with a blade to get rid of the larger chunks. After that I just sand what ever is left with 200 grit sandpaper. That usually takes care of what gets left on mine. Good luck!
Link to post
Share on other sites