Jump to content
Ultimaker Community of 3D Printing Experts
  • Sign Up
nigelwebb

Wrong size of print with Cura 2.3 and 0.8 nozzle

Recommended Posts

Posted · Wrong size of print with Cura 2.3 and 0.8 nozzle

Hi,

I have just printed two different but similar parts that look like concentric rings joined with spokes.

Due to the size of the parts, and the very long printing time, I changed from a 0.4mm nozzle to a 0.8mm nozzle.

After printing I measured the parts.

Note: I require the parts to have a good diameter tolerance, something like +/-0.1mm.

All the outside diameters are correct to the model, BUT all the inside diameters are too small by about 0.5/0.6mm. This is the same on both different, but similar, parts.

I investigated the possibility that due to the size of the part (about 200mm) that this could be shrinkage, but that cannot be the case as the small inside diameters are out by the same as the large inside diameters (both 0.5/0.6mm).

Is this a known feature? Can it be corrected?

20161121_093133.thumb.jpg.d0a0ab870fc8ebfc585dd14400dab35c.jpg

Thanks

Nigel

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Essentials
      Ultimaker Essentials is an enterprise-grade package of Ultimaker software products with greater stability, uniformity, and a higher level of security. 
      • 0 replies
    • Cura settings: Improving naming and descriptions
      - Maybe you'd like to see more detailed descriptions for each setting?
      - Maybe you'd like to see some settings in a different category?
      - Maybe you'd like to see a completely new category?
       
      Give us your feedback in this thread and we'll consider it for future releases.
        • Like
      • 5 replies
×
×
  • Create New...