Jump to content
Ultimaker Community of 3D Printing Experts

end-start script gcode in Cura 2016


Recommended Posts

Posted · end-start script gcode in Cura 2016


I read a lot of posts regarded on web but I could not figure out where to find endscript / StartScript gcode in Cura.

I use Cura 15.04.06 on Macbook Pro and Cura 2.3.1 on iMac but i can't find it...

Can you help me?

I need to change the value in M207 - G10 reducing millimeters retraction at the end of the process

Thank you

  • Link to post
    Share on other sites


    This topic is now archived and is closed to further replies.

    • Create New...