Jump to content
Ultimaker Community of 3D Printing Experts

Gaps between outer shell and bottom\top infills


Darth_Biomech

Recommended Posts

Posted · Gaps between outer shell and bottom\top infills

I increased the infill overlap value in Cura to 38%, bumped extrusion speed to 120%, raised temperature of printing, but there are still gaps. I am printing at Ultimaker 2 (not 2+) with ABS. Sliced with Cura is 15.02.1, since I cannot use more recent versions due them slicing my models incorrectly (Thread about that), but I've used this version for a while, and this issue is only developed relatively recently, so I am suspecting that something must be up with the printer itself.

untitled_by_darth_biomech-daqbfmp.jpg

It doesn't look like underextrusion (which is usual culprit of "stuff doesn't connect!"), though, since everything else is printing as expected and without any issues.

  • Link to post
    Share on other sites
    • 3 weeks later...

    Archived

    This topic is now archived and is closed to further replies.

    ×
    ×
    • Create New...