Jump to content
Ultimaker Community of 3D Printing Experts

Filiment all tied up


MechDesigner
 Share

Recommended Posts

Posted · Filiment all tied up

My last post my filament un-rolled like a garden hose,

Now I am having problems with the filament getting knotted up.

I have a half empty roll that will not stay un-tangled, I tried a new roll of PLA,

and it tied up in a knot. The new roll went on fine, Added the material to the printer,

then after it starts to print the filament roll looses up, you can hear it unravel, then parts of it pops off the real, then ties into a knot.

Will any of the hacks where they rotate the roll 90deg fix my problem.

5a332585114db_Filimentroll.thumb.jpg.8bc8491828bd82c62902da185b684419.jpg

Thanks

Frank

5a332585114db_Filimentroll.thumb.jpg.8bc8491828bd82c62902da185b684419.jpg

  • Link to post
    Share on other sites

    Posted · Filiment all tied up

    I feel your pain!

    I had a roll of Ultimaker Silver PLA (newer stuff) do the exact some thing. It was bound up bad inside the roll a few layers.

    Overnight I had a roll of Colorfabb nGen filament do the exact same thing. I have filament guides that seem to help gently unfurl some snags. However this one was inside the roll and tore off the filament guides !

    In the nGen case, I had to unfurl a couple feet of tangles and clip them off.

    And in moth instances these were new rolls that had only done 2 or 3 small (4 hour) prints. So not the beginning of the roll but a few feet into them.

    • Like 1
    Link to post
    Share on other sites

    Posted · Filiment all tied up

    I'd say... just unroll untill your roll appears clear... then either re-roll... or snip it off and try rolling the difficult bit onto an empty roll... if you have the time.

    And yes... a lot of the time you will twist the entire roll whilst re-winding... It's really a question of feeling the tension and rolling as relaxed as possible (no twists).

    • Like 1
    Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...