Jump to content
Waternut13134

Wifi Not Working?

Recommended Posts

Posted (edited) · Wifi Not Working?

So ive run into a weird issue,When I went to cura to send a print over wifi I noticed it didnt see my UM3. So I checked the status on the connection on the printer and didnt see an IP address or anything. So when I go an try to rerun the wifi set up it just sits at creating a wifi hotspot,And I mean it sat for over an hour doing this,When I cancel it just defaults back to LAN,I have tried running an ethernet cable to the printer and it instantly pulls an IP address so I believe it has something to do with the WIFI Module? However I prefer wireless as I currently am running a 150FT ethernet cable across the house lol I have unplugged the system and router/modem to not success. Any ideas on whats going on? Thanks!

Edited by Guest

Share this post


Link to post
Share on other sites
Posted · Wifi Not Working?

Well I tried a factory restart as I lost connection on wired as well,The UM3 said it was restarting and the screen just went blank and the lights stayed on,I left it like that for about 1 hour and went ahead and turned the machine off and back on again,Now nothing!!!!! I hear 2 clicks under the machine and nothing,No lights or anything,The only light that is on is the little red light under the machine. Any thoughts? =(

Share this post


Link to post
Share on other sites
Posted · Wifi Not Working?

please contact your reseller, because you have a problem with your wifi board.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!