UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Ich habe das gleiche Problem mit PET gehabt. Bei einen Dual Druck mit PET und PLA konnte ich von Hand auseinander brechen. Da ich aber nur eine Rollte PET hatte habe ich und dies so und so nicht gut drucken lässt liegt es seither im Schrank!
Warte mal PETG ist doch ähnlich wie das XT von ColorFabb!!
Ich habe das PolySupport im Einsatz da hatte ich keine Probleme mit dem XT Material.
Info: Du musst beim Drucken mit Support Material den Z-Abstand auf 0 runtersetzen!
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
(Sorry, was out of office when this released)
This update is for...
All UltiMaker S series
New features
Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
Recommended Posts
zerspaner_gerd 382
Hallo Novastorm,
Ist PET und PETG das gleiche??
Ich habe das gleiche Problem mit PET gehabt. Bei einen Dual Druck mit PET und PLA konnte ich von Hand auseinander brechen. Da ich aber nur eine Rollte PET hatte habe ich und dies so und so nicht gut drucken lässt liegt es seither im Schrank!
Warte mal PETG ist doch ähnlich wie das XT von ColorFabb!!
Ich habe das PolySupport im Einsatz da hatte ich keine Probleme mit dem XT Material.
Info: Du musst beim Drucken mit Support Material den Z-Abstand auf 0 runtersetzen!
Gruß Gerd
Link to post
Share on other sites
Novastorm 12
Hallo Gerd,
Polysuport habe ich auch noch, das könnte ich mal Probieren. Mit dem Z Abstand werde ich auch beim nächsten Druck mal testen.
PET-G hat den Zusatz Glycol im gegensatz zu PET, was es ihm zum 3D drucken bessere eigenschaften verleiht. Soll besser fließen als PET.
Ja das PETG ist ähnlich wie das XT von ColorFabb.
Link to post
Share on other sites