Jump to content
Ultimaker Community of 3D Printing Experts

Melting thin wall print


Recommended Posts

Posted (edited) · Melting thin wall print

Hi Guys,

Any idea on why this happens in some areas of this thin wall print? It's part of an RC Airplane wing.  It happened at the top of the print and a small patch halfway up.

Using Ultimaker clear PLA at 215degC,  plate at 60degC, 30mm/sec print speed.

Didn't seem to happen with exact same settings using White PLA or an earlier version on the other half of the wing (opposite side).

Could the room temperature cause this?  Was a bit warm in the room where the printer lives today.

Cheers

Jason

DSC_0547.thumb.JPG.de94166388659b566fed2e8ad109ad3c.JPG

DSC_0548.thumb.JPG.1d30800c7dad723a1c3ed8d913690019.JPG

Edited by Guest
  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...