Your bed isn't perfectly calibrated. Try to check https://ultimaker.com/en/resources/18769-calibration
It looks like your bed is a little bit too low.
Mostly noticeable in surface finish, white PLA is not the most forgiving material to print with. The added pigment to make it white can influence its behavior.
Neotko and SandervG thank you for your help. This morning I re-calibrated and the prints are much better. I really appreciate the help
- 1
Recommended Posts
AlmondPA 1
Does quality of the PLA make a difference. I just loaded some ColorFabb and the print looks solid. Think this might be coincidence or PLA quality does make a difference?
Link to post
Share on other sites