A few hours usually. 2-3 hours maybe a bit more if its been in the polisher awhile.
no chance, i dont handle it...
also the polymaker support, said my mist is ok, the isopropanol is the same manufacturer they advise me too....
i think the hole product is junk....
it dont work
here you see my results...
No idea, i have made parts for customers and they were fine.
Although I am not impress by their claim you can use PVA supports, because the results were very bad.
can you please show me a print without polyshing and after the polysher please?
a best with some more pictures, like i do with using light to see the surface sturcture
Sure thing, i'll snap a pic next time i get a poly order.
-
Our picks
-
UltiMaker Cura 5.7 stable released
ArunC posted a topic in UltiMaker Cura,
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
-
-
- 18 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
Release Notes: S-Line Firmware 8.3.0 (Latest)
Dustin posted a topic in Firmware,
S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
(Sorry, was out of office when this released)
This update is for...
All UltiMaker S series
New features
Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.-
-
- 0 replies
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
Edel 5
ok, after reading in the internet about isopropanol i found out that i can mix my 99,9%
with water to get 90%.
i will do this test tommoror and in which time should it be hard again?
my parts are now 4 days after soft, that i can damage it with my finger nail
Link to post
Share on other sites