Jump to content
Tommy_768

Ultimaker 3 Extended Reboot at XY offset and print trial

Recommended Posts

Posted · Ultimaker 3 Extended Reboot at XY offset and print trial

Hi,

We've just bought and received an Ultimaker 3 Extended. Out of the box we tried to make a calibration XY offset. The first steps of the setup are almost ok, we are able to load one material, the second nfc is not detected but we manually override it.

When we try to calibrate the printer shut off and reboot! It happens the same when we launch a print! For a box a 4000€ printer! :(

Where could the problem come from??

Thank you for you answer

Share this post


Link to post
Share on other sites
Posted · Ultimaker 3 Extended Reboot at XY offset and print trial

I would update the firmware. Maybe yours has an older version. Afaik they solved that issues.

  • Like 1

Share this post


Link to post
Share on other sites
Posted · Ultimaker 3 Extended Reboot at XY offset and print trial

I have similar problem. Did you find a solution to the problem?

 

What firmware are you running? Run the latest stable version.

  • Like 1

Share this post


Link to post
Share on other sites
Posted · Ultimaker 3 Extended Reboot at XY offset and print trial

Same problem here, any known solutions?

Have you tried a factory reset?

What firmware are you running?

Is this happening during prints, or just the XY calibration?

  • Like 1

Share this post


Link to post
Share on other sites
Posted · Ultimaker 3 Extended Reboot at XY offset and print trial

Hi,

Did anyone figure out the solutin to this . I am facing the same issue. The printer restarts when I try to XY calibrate.

It would be great if the ultimaker teams responds .

Thanks

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 182 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!