Jump to content
Ultimaker Community of 3D Printing Experts

Cura ignoring/biasing temperature setting?


lairdb

Recommended Posts

Posted · Cura ignoring/biasing temperature setting?

I'm trying to move from 15.04.6 to 2.x (currently have 2.3 and 2.4 installed); I've been able to print PLA with good results. However, I'm having a terrible time getting my TPU to print with 2.3 or 2.4. Have worked carefully to migrate settings that work very well in 15.04.6, and still getting awful results.

Mystified as to what's going wrong, although it looks a little like under-extrusion, but I am frustrated enough to be opening the GCode files and comparing, and that led me to:

2017-02-26%2010_46_05-Cura.png

Why is 2.4 setting temperature 5 degrees higher than specified?

(Also, if anybody has hints about why apparently identical 15.04/2.4 profiles are yielding great/horrible results for TPU, that'd be great.))

  • Link to post
    Share on other sites

    Archived

    This topic is now archived and is closed to further replies.

    ×
    ×
    • Create New...