[[Template core/front/global/favico is throwing an error. This theme may be out of date. Run the support tool in the AdminCP to restore the default theme.]] Jump to content
Ultimaker Community of 3D Printing Experts

NinjaTek - Armadillo


BrayChristopher

Recommended Posts

Posted · NinjaTek - Armadillo

Hi, i´m printing with a 0.6 noz and 0.3mm height. Print speed depends on the model, between 12 and 40mm/s .. temp is 230 and 80 bed. Using a bit of glue stick on the bed. Using the TPU preconfiguration and run the modification on top.. don't use it too hot, looks that the print gets bad if it is rather too hot or under extruded. But in the end, much easier to print, compared to ninjaflex..

  • Link to post
    Share on other sites

    Archived

    This topic is now archived and is closed to further replies.

    ×
    ×
    • Create New...