Yes, that WOULD be good to know! Thanks.
This should be stickied, be cause it has come up before and will come up again:
Cura has a new setting named Initial Layer Temperature which defaults to the normal temperature +5. This is only for the first layer.
We didn't listen quick enough so this messed with peoples settings. Sorry about this. It has been changed for 2.5. There only the UM printers have this behavior.
It is in the changelog however.
Recommended Posts
ahoeben 2,026
This should be stickied, be cause it has come up before and will come up again:
Cura has a new setting named Initial Layer Temperature which defaults to the normal temperature +5. This is only for the first layer.
Link to post
Share on other sites