Jump to content
Ultimaker Community of 3D Printing Experts
mprowe

Settings in Cura 2.3.1. How?

Recommended Posts

Hi,

I am trying to make changes in Cura (Linux 64bit) to resolve some problems. The advice to to set a value in the relevant settings location. However, all the settings I can find are check boxes.

For example, how can I set a Line Width to 0.5mm when all I can see is this:

cura.png.250e5bb7bca0eb41fa9dc1a4faa4e749.png

The Line Width is Checked or Unchecked!

Regards, Martin

cura.png.250e5bb7bca0eb41fa9dc1a4faa4e749.png

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Taking Advantage of DfAM
      This is a statement that’s often made about AM/3DP. I'll focus on the way DfAM can take advantage of some of the unique capabilities that AM and 3DP have to offer. I personally think that the use of AM/3DP for light-weighting is one of it’s most exciting possibilities and one that could play a key part in the sustainability of design and manufacturing in the future.
        • Like
      • 3 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!