UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Still annoying though. There are at least two links to open dirs on http://software.ultimaker.com/'>http://software.ultimaker.com/ current ly that allow you to download Cura without going through the survey. Can you believe I found the other one by googling around the domain http://software.ultimaker.com/ ?!
The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
Recommended Posts
ahoeben 1,849
Still annoying though. There are at least two links to open dirs on http://software.ultimaker.com/'>http://software.ultimaker.com/ current ly that allow you to download Cura without going through the survey. Can you believe I found the other one by googling around the domain http://software.ultimaker.com/ ?!
Link to post
Share on other sites
THX1138 1
I didn't realise it was possible to escape the survey.
Link to post
Share on other sites