Jump to content
Produktdesigner

Düse verstopft

Recommended Posts

Posted · Düse verstopft

Hallo,

ich habe seit einigen Wochen eine Ultimaker3. Jetzt scheint nach wenigen Drucken die Düse des Filament verstopft zu sein. Wie kann man die reinigen?

Gruss Moosbach

Share this post


Link to post
Share on other sites
Posted (edited) · Düse verstopft

cold pull zum reinigen.

use original filament when printing.

use standard profiles, not high temp, not high speed.

never mix abs / pla in same core.

what filament are you printing?

Edited by Guest

Share this post


Link to post
Share on other sites
Posted · Düse verstopft

Instructions to clean your print core with hot pulls and cold pulls are here. The AA core can be cleaned in the same manner, however, that is seldomly necessary.

You state that you think your nozzle is clogged. What makes you think that?

If there is a mixture of Nylon and PLA in your print core, manually set the temperature to 260, and press some Nylon through the print core. You can best do that directly from the top of your printhead, after removing the bowden tube. Instruction are in the document linked above. Make sure you put the print head in one of the corners, to prevent bending the shafts that suspend the printhead.

We advise to use different print cores for different materials, so flushing it is not necessary.

Share this post


Link to post
Share on other sites
Posted · Düse verstopft

Agree @tomnagel. When you print with PLA and change to Nylon ( higher temp) then residue of PLA in the Core is cooked to carbon or chewing gum.. It sits there and makes problems for you.

Repeated cold pulls!

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 181 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!