Jump to content

Back side stepper motor vents

mhotze

By mhotze
in UltiMaker 3D printers

 Share

Recommended Posts

mhotze

mhotze 7

Posted
Posted · Back side stepper motor vents

Idea: have stepper motor vents at backside plane instead of vent holes inside the chamber. This gives more thermal headroom for the stepper motors when mounting a front door (or even further enclosing the chamber).

By the way, I measured so far motor temperatures below 60C in all scenarios so far, but not going to extremes either.

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.4 stable released

        UltiMaker Cura 5.4 stable released

        ArunC posted a topic in UltiMaker Cura,

        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...