Cura 2.4.0 "Save to removable drive" only works with the first registered printer

[Olaf 0]

Hello,

I am using Cura 2.4.0 on a Windows 7 64-bit computer. I have set up two different 3D printers in Cura. In former Cura versions, the "Save to removable drive" button always worked with my SD card reader (L:\). In Cura 2.4.0, it stopped working. But I found out that it only refuses to work with the second 3D printer. Then it just does not save the file. A notification window appears in the lower center of the screen, but there is no text in it except the "close message X" (the cross in the upper right). When I switch back to my first 3D printer, then the button works normally. It seems that Cura 15.04.6 does not show this issue (also two printers registered).

Does anybody else have this issue with Cura 2.4.0? Is it known? Any chance to put it on the to-fix list?

Thanks,

Olaf

Edited March 22, 2017 by Guest