Jump to content
lance-greene

cura 2.4 print 1 at a time retraction issue

Recommended Posts

Posted · cura 2.4 print 1 at a time retraction issue

so ive been printing a bunch of spinners lately and am printing 4 on a buildplate, using the "print 1 at a time" setting. I've noticed that when it finishes 1 and then retracts and moves to the position of the next spinner, there is no extrusion for almost the entire skirt and it just barely manages to start extruding when the skirt is finished and the print starts.

i think it might not be priming as far as it is retracting when it is set to "print 1 at a time"

Share this post


Link to post
Share on other sites
Posted · cura 2.4 print 1 at a time retraction issue

Hi

I can confirm this. I am sure its a bug. I have increased skirt line count to get round it.

Ian

Share this post


Link to post
Share on other sites
Posted · cura 2.4 print 1 at a time retraction issue

Which version of Cura are you running?

When did you last update the firmware on the printer?

Share this post


Link to post
Share on other sites
Posted · cura 2.4 print 1 at a time retraction issue

Hi

Just seen this. Raised an issue on Git and the problem is now fixed.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!