Jump to content
twofoot

What could be causing this print issue?

Recommended Posts

Posted · What could be causing this print issue?

Hi folks. Quite suddenly, my machine now prints vertical faces at a slope as seen in the attached photos. Any ideas as to what could be causing this.

The holes in the thicker section should also be round, not oval. I apologize if the brim makes the photo a bit confusing.

Thanks!

Chris

fbz0c7.jpg

10392qw.jpg

Share this post


Link to post
Share on other sites
Posted · What could be causing this print issue?

Normally I'd say - check your pulleys and the belt tension. But the main object has straight edges but the small one does not.

Can you rule out slicing problems?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!