Jump to content
Ultimaker Community of 3D Printing Experts

Inconsistent movement in print


yingxu

Recommended Posts

Posted · Inconsistent movement in print

Hi,

We hope someone here can provide some advice about the movement in the printing process.

Without adjusting anything, we have noticed that with every print, the head would start in one speed for maybe 5mm of height, then decide to slow down for another 5mm, then change to the faster speed again, and will alternate between the two speeds until it finishes.

We have guessed that it might have something to do with Print Acceleration and Jerk settings, however, after adjusting those setting in Cura, there has been no noticeable difference.

If someone here would have some insight, we would appreciate it very much!

Sincerely,

Ying

  • Link to post
    Share on other sites
    Posted · Inconsistent movement in print

    There are many different jerk and acceleration settings which are hidden. Try to display them all, and maybe you can get the behavior you expect.

    But of course I advise to stick to all default settings, cause usually these are really good

  • Link to post
    Share on other sites

    Archived

    This topic is now archived and is closed to further replies.

    ×
    ×
    • Create New...